28 06 2016
(2016.6 NEW)Free Braindump2go 200-310 PDF Dumps 277Q&AsDownload(NQ21-NQ30)
!!!2016 Cisco Official New!!! CCDA 200-310 – Designing for Cisco Internetwork Solutions (DESGN) Exam PDF and VCE Dumps with New 200-310 Exam Questions Updated Today in Braindump2go.co for Free Instant Download! 100% Exam Pass Guaranteed!
NEW QUESTION 21 – NEW QUESTION 30:
2016 Latest Cisco 200-310 PDF Dumps & 200-310 VCE Dumps 277q Download:http://www.braindump2go.com/200-310.html
200-310 PDF & 200-310 VCE 277Q&As Dumps – Google Drive:https://drive.google.com/folderview?id=0B272WrTALRHcWEt3eDd0a0dqQ00&usp=sharing
100% Exam Pass Promised by Braindump2go.com!!!
Which factor would be most influential in choosing multimode fiber optic connections over UTP?
A. signal attenuation
B. required bandwidth
C. required distance
D. electromagnetic interference
A hierarchical design of the EIGRP domain facilitates which two of the following? (Choose two.)
A. route summarization
B. faster convergence
C. unequal cost load balancing
E. virtual links
Which three types of WAN topologies can be deployed in the Service Provider Module? (Choose three.)
C. full mesh
E. collapsed core
F. partial mesh
Which of the following is a component within the Cisco Enterprise Campus module?
C. Internet Connectivity
D. Building Distribution
E. WAN/MAN Site-to-Site VPN
Which two features are supported by single wireless controller deployments? (Choose two.)
A. automatic detection and configuration of LWAPPs
B. LWAPP support across multiple floors and buildings
C. automatic detection and configuration of RF parameters
D. Layer 2 and Layer 3 roaming
E. controller redundancy
F. mobility groups
Which three describe challenges that are faced when deploying an environment for teleworkers? (Choose three.)
A. supporting a mix of technically knowledgeable and nontechnical users
B. simplifying router installation and configuration
C. verifying available power at employee’s house for necessary equipment
D. avoiding situations where employees might use nonstandard hardware or configurations
E. reducing daily commuting time to main office location
F. providing access to FTP servers located in main office location
G. implementing leased line connectivity between main office and employee’s home location
Which statement describes the methodology that supports the Cisco Enterprise Architecture models?
A. It divides the network into functional network modules.
B. It divides the network into role-based network modules.
C. It divides the network into regional network modules.
D. It divides the network into operational network modules.
OSPF will be used as the IGP within a campus network. Which two things should you consider before deployment? (Choose two.)
A. All areas need to connect back to area 0.
B. The OSPF process number on each router should match.
C. NSSA areas should be used when an area cannot connect directly to area 0.
D. Stub areas should be connected together using virtual links.
E. ECMP may cause undesired results depending on the environment.
Which is the North American RIR for IPv4 addresses?
An enterprise campus module is typically made up of four submodules, as described by the Cisco Enterprise Architecture Model. Which two submodules are part of this module? (Choose two.)
B. enterprise branch
C. building distribution
D. server farm/data center
Recommend!!! Valid Braindump2go Cisco 200-310 Exam Dumps with PDF and VCE 277q Dumps Download: http://www.braindump2go.com/200-310.html
[100% Exam Pass Guaranteed!]
More Cisco 200-310 Exam Quesrtions and Answers – Google Drive:
1.|Cisco 200-310 Exam Dumps and 200-310 Exam Questions 277q Download:
2.|Cisco 200-310 Exam VCE and PDF Dumps Download: