2018 March New Cisco 640-878 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 640-878 Real Exam Questions:
1.|2018 Latest 640-878 Exam Dumps (PDF & VCE) 140Q&As Download:
2.|2018 Latest 640-878 Exam Questions & Answers Download:
Your switch network has been configured to support multiple VLANs. In order for the users on one VLAN to communicate with users on another VLAN, which additional configuration is required?
A. Enable a routing protocol like EIGRP on a router or on a Layer 3 capable switch
B. Enable inter-VLAN routing on a router or on a Layer 3 capable switch
C. Enable a switch virtual interface on the router, using the interface vlan global configuration command
D. Enable a switch virtual interface on the switch, using the encapsulation dot1q
E. subinterface configuration command
F. Enable IP routing on a Layer 2 switch
Within an MPLS domain, which table is used by the label switch routers to make forwarding decisions when a labeled packet is received?
On Cisco IOS XR software, what is the default commit option?
Refer to the show command exhibit. Which statement is true?
A. It shows the result of the target configuration merged with the running configuration.
B. It shows the contents of the uncommitted configuration.
C. It shows the contents of the failed configuration.
D. It shows the contents of the running configuration.
When configuring a new VLAN on Cisco IOS switches, which configuration parameter is required?
A. VLAN name
B. native VLAN ID
C. VLAN ID
D. VLAN map
E. VLAN MTU
What is a requirement for performing Cisco IOS ISSU on the Cisco IOS XE-based ASR 1006 and ASR 1013 routers?
A. must use consolidated package mode
B. must use subpackage mode
C. must have redundant RPs
D. must have owner and nonowner SDRs
Refer to the partial Cisco IOS router configuration exhibit. Which statement is true?
A. To support the subinterface configuration, the Fa0/0 main interface configuration is missing the
encapsulation dot1Q command.
B. The Fa0/0 interface/subinterfaces are configured correctly to operate as a trunk port to provide
inter-VLAN routing for three VLANs (VLANs 1, 2, and 3).
C. To provide inter-VLAN routing, the Fa0/0.1, Fa0/0.2 and Fa0/0.3 subinterface configuration is
missing the encapsulation dot1Q vlan-id subinterface configuration command.
D. To provide inter-VLAN routing, the router is missing the vlan 1, vlan 2, and vlan 3 global configuration
Refer to the partial Cisco IOS XR BGP configuration exhibit. Which two statements are true? (Choose two)
A. This router uses its Loopback 0 interface IP address when establishing BGP peering with the
B. This router uses its Loopback 0 interface IP address when establishing BGP peering with the
C. Test1 refers to a route policy that is defined using the RPL.
D. Both the IBGP and EBGP sessions will be authenticated.
E. The IBGP session is missing the mandatory route-policy configuration.
When is a route-policy configuration needed on a Cisco IOS XR router using RPL?
A. when enabling an IGP routing protocol configuration
B. when enabling an EBGP peering configuration
C. when enabling an IBGP peering configuration
D. when enabling route redistribution
E. when enabling an LDP peering configuration
Refer to the partial Cisco IOS router configuration exhibit. Which type of tunnel configuration is shown?
A. GRE tunnel
B. manual 6in4 tunnel
C. 6to4 automatic tunnel
E. IPv4-in-IPv6 tunnel
Which two protocols are most often deployed in Cisco IP NGN multiservices core networks to support services like VPNs? (Choose two.)
F. multiprotocol BGP